Helmholz 700-640-CAN21 CAN 400-2, with 2 CAN interfaces

Kod: 700-640-CAN21

Marka: Helmholz

The CAN 400 module, for use in an S7-400* from Siemens, enables connection of CAN participants with the automation device.
The module can be plugged into either the central frame or the expansion frame.
It supports CAN 2.0A (11 bit) and CAN 2.0B (29 bit) frames with a freely selectable transfer rate from 10 kbps to 1 Mbps.
The module contains the scripts for “Power On”, “Stop -> Run”, “Run -> Stop”, “Power Off”. Using a multi-stage acceptance mask, relevant IDs can be pre-filtered for the automation device.

The CAN 400-2 can be operated as Layer 2, CANopen® master or CANopen® slave.
With the module, 16 freely settable timers up to a resolution of 1 ms are available. Each timer can trigger a freely programmable CAN telegram. This means the synchronous protocols widely available in drive and servo control are also easy to implement using the CAN 400-2.

Layer 2, 11 bit and 29 bit (CAN 2.0A/B)
DIP switches for address + transfer rate
USB interface for parameterization and diagnostics
Extensive CAN bus diagnostics possibilities
Can also be used as CANopen master or CANopen slave
2 CAN interfaces

General information
	Order number	700-640-CAN21
	Article name	CAN 400-2, with 2 CAN interfaces
	Scope of delivery	CAN 400-2
	Dimensions (DxWxH)	290 x 210 x 25 mm
	Weight	Approx. 900 g
CAN interface
	Number	2
	Type	ISO/DIN 11898-2 CAN High-speed physical layer
	Transmission rate	10 kbps ... 1 Mbps
	Protocol	* CAN 2.0A (11 bit)/CAN 2.0B (29 bit) Layer 2 CANopen® Master/CANopen® slave * SAE J1939
	Connection	Connector, SUB-D, 9-pin
Status indicator		6 LEDs
Configuration interface
	Type	USB 1.1
	Connection	USB B socket
Voltage supply		+5 V DC via backplane bus
Current draw		600 mA
Ambient conditions
	Ambient temperature	0 °C … +60°C
	Transport and storage temperature	-25 °C … +75 °C
	Pollution degree	2
	Protection rating	IP20
	Certifications	CE